Induction Innovations GB-20311 Inductor Glass Blaster Kit, Auto Glass and Undercoating Removal Tool
- The Induction Innovations GB-20311 Glass Blaster Kit is designed to quickly and safely remove bonded auto glass, undercoating, adhesives, and spray-on bedliners using flameless induction heat. It removes windshields from the exterior in under fifteen minutes without damaging surrounding trim, paint, or non-metal components.
- Features:
- Flameless induction heating system eliminates the need for torches, reducing risk of fire or damage.
- Operates on standard 120 volt, 20 amp circuits for compatibility with typical workshop power supplies.
- Ergonomic setup includes heat-resistant L-wedges, a pneumatic foot switch, and a hard-wired U-311 attachment for precision control.
- Safe for use on glass, paint, and plastic since induction heat targets only ferrous metal surfaces.
- Contoured induction attachments deliver concentrated heat in corners, deep pockets, and curved areas.
- Equipped with a UL-listed Ground Fault Circuit Interrupter (GFCI) for operator safety.
- Includes:
- Carrying case
- (2) Heat-resistant L-wedges
- Hard-wired U-311 induction heater attachment
- Instruction manual
- Specifications:
- Manufacturer: Induction Innovations
- Part Number: GB-20311
- Power Requirement: 120 volts, 20 amps
- Power Output: 2,000 watts
- HF Cord Length: 9 inches
- Dimensions: 22.5 inches x 11 inches x 10.5 inches
- System Compatibility/Application: Specifically designed for bonded auto glass removal, adhesive release, undercoating, spray-on bedliners, and SMC panel applications where traditional cutting tools or torches may cause damage
- The Inductor GB-20311 Glass Blaster Kit can also be referred to as an auto glass induction heater kit, urethane bond removal tool, adhesive release system, or body shop glass removal tool.
Induction Innovations builds the GB-20311 Glass Blaster Kit as a safe, efficient alternative to cutting or torch methods. By focusing heat through induction on metal surfaces only, it allows technicians to remove bonded glass and coatings quickly while protecting nearby materials.
Q: How long does it take to remove a windshield?
A: The Glass Blaster can remove quarter glass in under three minutes and windshields in about fifteen minutes when used from the exterior.
Q: Does the tool damage surrounding materials?
A: No. Since it heats only ferrous metals, surrounding glass, paint, trim, and plastics remain undamaged during use.
Q: What power supply is needed?
A: The unit requires a standard 120 volt, 20 amp circuit to operate effectively and safely.
