Loctite 263 Threadlocker Red, Surface Insensitive, 36 ml Bottle (2205310)

Loctite 263 Threadlocker Red, Surface Insensitive, 36 ml Bottle (2205310)

• LOCTITE 263 is a red, dual cure, acrylic dimethacrylate ester fluorescent threadlocker designed for the permanent locking and sealing of threaded fasteners
• It cures between close fitting metal surfaces and prevents loosening and leakage from shock and vibration
• It works on active metals (e.g. brass, copper) and passive substrates such as stainless steel and plated surfaces
• Features
  • Particularly suited for heavy duty applications such as studs into motor housings where high strength is required
  • Prevents loosening and leakage from shock and vibration
  • Designed for the permanent locking and sealing of threaded fasteners
  • Provides robust curing performance
  • Offers high temperature performance and oil tolerance
• Specifications
  • Agency Approvals / Certificates / Specifications: NSF/ANSI 61
  • Application Method: Dispense System, Manual
  • Application Temperature: -65.0 - 360.0 °F (-55.0 - 180.0 °C )
  • Applications: Threadlocking
  • Breakaway Torque, M10 Steel Nuts/Bolts: 33.0 N·m (290.0 in./lb. )
  • Color: Red
  • Cure Type: Anaerobic Cure
  • Fixture Time: 10.0 min.
  • Key Characteristics: Disassembly: Disassembly with Heat, Fluorescent, General Purpose, Oil Tolerant, Primerless, Strength: High Strength
  • Physical Form: Liquid
  • Prevail Torque, M10 Steel Nuts/Bolts: 33.0 N·m (290.0 in./lb. )
  • Specific Gravity, @ 25.0 °C: 1.1
  • Substrates: Metal, Metal: Passive Metal
  • Technology: Acrylic
  • Viscosity, 20 RPM: 500.0 mPa·s (cP)
  • UPC: 079340011656
• How To
  • 1. Preparation - Cleaning
    • It is recommended to use LOCTITE SF 7070 to degrease and clean surfaces prior to applying threadlocker.
  • 2. Preparation - Activation
    • If cure speed is too slow due to passive metals (stainless steel, aluminum and plated metals) or low temperature (below 5°C), use LOCTITE SF 7649 activator. Allow to dry.
  • 3a. Application - Through Hole
    • Apply a few drops of liquid threadlocker to the thread engagement area. Assemble nut and tighten to proper torque.
  • 3b. Application - Blind Hole
    • Apply several drops of liquid threadlocker into lower third of blind hole, as well as a few drops onto male threads, and then install male threads. Tighten to proper torque.
  • 4. Assembly
    • Assemble and tighten to proper torque requirement. If several bolts are being assembled, torque them down to the correct value within the fixture time window.
  • 5a. Disassembly - Hand Tools
    • Disassemble with standard hand tools.
  • 5b. Disassembly - Heat
    • If disassembly is not possible using normal hand tools, apply localized heat to approximately 500°F/260°C. Disassemble while hot with standard hand tools.