3M 06061 Perfect-It Extra Cut Rubbing Compound, 1 Gallon
- The 3M 06061 Perfect-It Extra Cut Rubbing Compound is a liquid cutting polish designed to aggressively remove P1200 and finer sanding marks while leaving a fine swirl mark finish, especially on modern cured paint systems.
- Features:
- Fast cutting action restores dull or oxidized finishes and removes fine sanding scratches.
- Leaves a controlled fine swirl mark finish that’s easier to polish out.
- Free of waxes, silicones, and fillers, reducing the risk of interfering residues.
- Formulation offers excellent handling and cleanup characteristics.
- Compatible with a wide range of modern paint and clear coat systems.
- Specifications:
- Manufacturer: 3M
- Part Number: 06061
- Size: 1 gallon (3.78 L)
- Type: Extra Cut rubbing compound (high cut)
- Removes: P1200 and finer sanding scratches
- Appearance: Off-white creamy liquid (from SDS)
- VOC: 168 g/L (per SDS)
- Flash Point: 188 °F (closed cup)
- System Compatibility: Use with foam, microfiber, or foam/polymer polishing pads; intended for body shop and finish correction stages before finer polishing.
- The 3M 06061 is sometimes referred to as 3M Perfect-It Extra Cut Compound, 3M 06061 polish, Perfect-It 3000 Extra Cut 06061, 3M Extra Cut rubbing polish, and 3M 06061 cutting compound.
3M is a global leader in automotive innovation, manufacturing high-performance products such as adhesives, abrasives, films, and detailing solutions that enhance vehicle design, repair, and maintenance efficiency.
Q: What is the ideal use case for 06061 Extra Cut Compound?
A: Use it after dry or wet sanding (especially P1200 and finer) to correct microscope scratches and oxidation before moving to finer polishes.
Q: Can this compound be used on all clear coats?
A: Yes, it is formulated to work on modern cured paint systems, but always test in a small area first and avoid over-aggressive buffing on thin or soft coatings.
Q: How should I apply it for best results?
A: Apply a small amount to the pad, spread initially at low speed, then use moderate speed with light pressure, working in small zones. Wipe off residue before final polishing.
