Overview
CTA 4040 GM Torsion Bar Tool
CTA 4040 GM Torsion Bar Tool
- Holds torsion bar while making adjustments
- Services:
- '88 - '10 GMC
- Chevrolet 1/2 ton, 3/4 ton and 1 ton pickups
- S-10 Blazer
- S-15 Jimmy
- 4WD pickups w/4.3L V6 engine
- '91-'01 Olds Bravada
- Interchange: 7822A
- Instructions
- REMOVAL:
- Attach Torsion Bar Unloader to frame rail of vehicle
- Tighten tool against the torsion bar adjusting arm
- Loosen or fully remove the adjusting bolt connected to the adjusting arm
- Count the number of turns in order to identify the original position of adjusting bolt
- When complete, remove tool and perform required service
- INSTALLATION:
- Attach Torsion Bar Unloader to frame rail of vehicle
- Tighten tool against the torsion bar adjusting arm
- Tighten tool, drawing torsion bar adjusting arm into the frame rail
- Tighten torsion bar adjusting bolt using the number of turns recorded in removal (Removal Step 2).
- Remove tool
- Check vehicle service manual for correct trim height and alignment specs