CTA 8084 Power Steering Pump / Alternator Pulley Remover & Installer Kit

CTA 8084 Power Steering Pump / Alternator Pulley Remover & Installer Kit

• Removes and installs press-on type belt driven accessory pulleys on pumps with 3/8”-16 threaded shafts
• Interchangeable components allow service on almost all domestic makes, including GM Quad 4, GM 3.1L and Ford 4.6L engines
• Impact quality tool
• Complete with instructions
• Packed in blow mold case
• Interchange: 38850, W89708, 4530, and 25298
• Instructions
  • REMOVAL INSTRUCTIONS:
    • Screw the threaded shaft into the removal housing, then insert proper removal pin into the hollow end of the shaft.
    • Engage the removal housing onto the recessed groove of the pulley.
    • Using a 3/4” wrench or socket, turn the threaded shaft clockwise until the pulley is removed (hold the removal housing/pulley stationary).
  • INSTALLATION INSTRUCTIONS:
    • Thread the proper installation nut all the way on the threaded shaft.
    • Slide on the first washer, then the thrust bearing, then the second washer.
    • Screw the proper threaded installing adapter into the threaded shaft.
    • Slide the pulley on the threaded shaft.
    • Screw the small end of the threaded shaft into the pump or alternator shaft hole all the way.
    • Using a 15/16” deep socket, rotate the installation nut clockwise to force the pulley onto the pump or alternator shaft (hold the pulley stationary).
• Components
  • 8084X03 - Installer - Quad 4
  • 8084X04 - Installer - GM 3.1L
  • 8084X05 - Installation Nut
  • 8084X06 - Installer - 3/8-16
  • 8084X07 - Installer - Ford 4.6L
  • 8084X08 - Universal Remover Pin
  • 8084X10 - Threaded Shaft